Just recieved a new one from AGD. Was trying to solve a problem where I was leaking out the back with the medium/cut spring on the LVL 10.
Popped the new reg piston in there, greased it up and assembled the gun. STILL leaking out of the back at 280ish velo. Oh well, I figure, guess I'll just have to use the short spring.
Adjust the Flatline for a little more input pressure. About 950ish. I'm test firing, and the next thing I know it sounds like I busted something. Crazy leak out of the back, and loud, too. Hold the trigger down, and then it becomes a pulsing leak. Turned the air off after that.
Popped the old reg piston back in and it works fine (still w/the short spring). Question: Will too much input pressure wreck a reg piston? After the crazy leak, I checked the guages and it red close to 1000psi input (it had went up a little).
Popped the new reg piston in there, greased it up and assembled the gun. STILL leaking out of the back at 280ish velo. Oh well, I figure, guess I'll just have to use the short spring.
Adjust the Flatline for a little more input pressure. About 950ish. I'm test firing, and the next thing I know it sounds like I busted something. Crazy leak out of the back, and loud, too. Hold the trigger down, and then it becomes a pulsing leak. Turned the air off after that.
Popped the old reg piston back in and it works fine (still w/the short spring). Question: Will too much input pressure wreck a reg piston? After the crazy leak, I checked the guages and it red close to 1000psi input (it had went up a little).