spongie trigger

[burstalot]

I replace my current minimag valve with the x valve with the lvl 10,every thing seems to be working fine after dry firing and shim and spring adjusment.I have no leaks i still need to adjust my velocity but i notice that my trigger is a bit spongie.I can press it a little less than 1/8" and it fires but it feels wierd compare to my old mag you press it 1/16 and boom it fired it was nice and crisp.now I press the trigger just to mess with it almost an 8th back and forth and it wont shoot just feels spongie.Like if the on /off valve would not be sensative to suck the pin, it seems I have to make more of an effort and i dont think thats normal. can anyone give me a hand is that normal or did i do something wrong.or does it go away after alot of use.

[Remington]

Welcome to AO! First, try cranking up your velocity until ir fires. If that doesn't work, check to see you have enough psi in your tank. Lastly, if the output pressure on your tank is less than 800 the trigger would be spongie(although i doubt this is your problem). Try PMing a tech if none of the suggested works. Good luck!

[athomas]

I would suggest turning up your velocity. The gun won't funtion properly until the velocity / chamber pressure is above the pressure that the gun will fire at.

[Smokee_2_7]

after you have done all of that, go ahead and check your o-rings in the on/off assembly. Any dirt on the o-rings where they contact the pin will cause the trigger pull to feel crappier than it should be. Also make sure that these same o-rings are oiled properly.



Carl