HELP powering the eMag board
I have an emag with a warp feed and revy hopper. We got the unit already modified, but recently had what seems to be the ground wire going to the battery come off the board. You would think you can just connect it anywhere on the board that is a common ground, but when we do, the LED's won't come on, even though the gun WILL trigger the warp feed and the revy hopper. Can someone tell me WHERE to get a REAL schematic for the board in the eMag? I've been to the airguns sight and it can't be found. Just general stuff that is NOT helpful. HELP !!!
-
-
The board is grounded to the frame where the screws holds it in the frame. The red wire that comes into the backside of the board is the power wire that pulls (+) current from the battery and powers the board. if that wire came off the board, then you need to strip off some of the insulator and resolder the wire back into the solder joint.
If the LED unit isn't working, but the gun is firing, then you fried the LED. AGD does not warranty any of the stuff you did to your gun, so you're going to have to pay full retail for the parts.
Comment