Paint problems with E-Mag and Warp

[Top Secret]

I played in a tourney today with my EMag with warp. The setup worked fine when I left for the tourney, but when I get in the damn game it turns into the BlendoPaint 2K1. WTF is going on here and will intellifeed solve it??

[Ityl]

Was the paint bad? Did it size up in the bore good? That's what it sounds like to me, paint problem.

[Cha0tic]

check the batteries in your warp. make sure your nubbins are not broken. make sure the pressure is up to 800-850.

[Russ]

Give more info. What kind of paint? barrel? Were others having paint problems? Are you chopping? Balls breaking in the barrel? Outshooting the Revy? Batteries new in both Revy and warp? Parabolic feed plug properly adjusted? Do pb's feed through the hose unimpeded? Sensitivity properly set?

Think about your question...

"I broke balls, what should I do?..."

Tough to help without all the details.

Note: I run my E-Mag w/warp at 600psi with no probs.

[Top Secret]

Brand new gun, stock bbl, new batteries, nubbins are fine, tested bbl in other mag, Warp-Feed runs fine until I hit the field, pressure holding at 600psi. Shreds 'em like a blender.

[Top Secret]

Sorry about the thread name, just a little pissed when I got home.

[BlackVCG]

Is it chopping in slow fire, or only rapid fire?

[Shaft]

http://www.automags.org/forums/showthread.php?s=&threadid=15224

Check out this thread. I had a similar problem this weekend. Tom posted the possible culprit.
Something that I may try out later this week.