Need some help on reg seats

[Paintballboy]

Hey guys, if you have seen my post before Im havin' some bad problems with my mag. I haven't fixed any of them yet cause I don't know what to fix. My problems are. My vertical asa is leaking piles of gas out.My oring on my tank is fine and vert, and my hoses are'nt clogged. My other problem is the space between the valve back anf front is leaking some air. I think it's my reg seat but i don't know where its located. If any one can get a pic of it and wheres its located please post it. Thanks.

[alf]

vertical ASA leaking: have you taken the elbow off, cleaned it, and the threads on your vertical, re-teflon taped the elbow and put it back in? this has happened to me MANY times, and re-taping the elbow fixes it.

space between the front/back leaking:
1. is your on/off put together correctly? (look at the diagram on the valve itself)
2. when you unscrew the valve halves, is there an o-ring on the back half of the valve? (should be around the outside...or close to the outside)
3. the reg seat is the clear "disk" with a hole in it that is between the valve halves when you unscrew them. when you install it, make sure it "snaps" into the rear half of the valve...if not, just turn it over and you will hear it kinda "snap/pop" in there, and it wont fall out when you hold the valve with the reg seat pointing down.

email me at [email protected], and i can send you pics

-alf