X-mag trigger problem in hybrid/manual modes

[souvy32]

I had some earlier problems which are almost resolved, but there is still a little snag. In electric mode, it rocks, no problems at all. When I switch it to hybrid or manual however, the trigger doesn't push out sometimes and it seems that the pin that is supposed to push it bak gets stuck. Any ideas or suggestions? Thanks a lot in advance.

[persistent]

me too

bump this up cause i'm having the same problem

[Jonesie]

Are you using the stock trigger or a blade trigger?

I have the blade trigger and it wouldn't work in Manual mode without an adjustment. You need to adjust the trigger rod out about 3/4 - 1 turn.

If it's the stock trigger, I'm totally sure. I'll see what I can dig up...

Later ~ Dave

[souvy32]

Well, I have a stock trigger and that's exactly what it was Jonesie. I actually took care of it a while ago and completely forgot to post it. After adjusting the trigger rod, you should be all set 'persistent'. good luck.