Tippmann 98 bottom line threading

[Cristobal]

I'm making a drop forward for a tippmann 98c and need to check on the specs for the bottom line attatchment holes in the base of the grip. I think they're threaded 10-32, spaced 3/4" on the centers -- is this right?

[ChucktheMAGician]

I'm to lazy to go measure it but it's the same size as every other gun, except Spyders of course!

[imahuron]

Yes 3/4" between centers. Most (all?) grips accept a #10-32 I believe the nominal size of a 10-32 is .19 (I've found most are just under 6/32 or .1875). Drill a few test holes to find the best bit.

[TheJester]

i thought they were a 10-32 thread with a 1/2 inch between centers, but it's been a loooooooooong time since i've measured

[imahuron]

It's 3/4". One can do miraculous things with a tape measure.