lvl 10 not cocking

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Abel
    Registered User
    • Aug 2001
    • 12
    #1

    lvl 10 not cocking

    hey...i just installed my lvl 10 kit and gassed it up...it doesn't leak...but it also dosent cock the bolt back inorder to fire...The set up i used was ( the carrier with 2 grooves, 2 shims) what type of set up should i use to fire about 280 fps...or around that...any info is greatly appreciated thank you
    Tags: None
    • askman
      Registered User
      • Feb 2002
      • 463
      #2
      frequently, you need to increase the velocity. higher pressure helps...

        Comment

        • JAM
          Back from the Dead
          • Jan 2003
          • 953
          #3
          If it's not leaking, it's probably fine, just crank up the velocity until it fires.
          sigs are overrated.

            Comment

            • yagrmiestr
              Eternal Tinkerer
              • Feb 2003
              • 212
              #4
              as you turn it up, you will probably want to go to the middle spring. At 280fps you the middle spring should work well.

                Comment

                • athomas
                  Of course it works-its AGD
                  • Jan 2002
                  • 8039
                  #5
                  If it doesn't allow the bolt to reset itself, then the carrier is probably too tight. Use the next size down and try that. Use lots of lubricant when breaking the carrier o-ring in.
                  Except for the Automag in front, its usually the man behind the equipment that counts.

                    Comment

                    Previous template Next
                    Working...