I have level 10 on my mag. And when i turn my velocity up it vents out the back. Even at 270-295 it vents out the back. Please help its annoying!
Do u have this problem?
Collapse
X
-
maginatorTags: None -
change springs
Switch the next smallest bolt spring. (If you have the long one in, put the middle one in, etc...) Readjust velocity and try again...Are you gonna bark all day little doggie........Or are you gonna bite?
___
Good traders: vf-xx, chris007, Prezents, Sgt. York -
maginator
thanks but i really dont want to go to the smaller spring because i am on the old one now and it will chop and break a pencil in the breech.Comment
-
maginator
the shinney one that is the same as the old will not fire and i moved up to a larger carrier. It helped but didnt totaly solve the problem and remember this is out the back no the barrelComment
-
Level 10
Mag,
I take it you started out with the two ring carrier. You also stated that you move up to the next larger carrier. I would keep trying until it leaked out the front and then drop down one size. These superbolts do require to be broken in I.E. shot atleast 1000-2000 rounds to seat in the oring and bolt stem. Also make sure to lube the internals, just pop off the air line and add a few drops before you play for the day. DO NOT OVER TORQUE the tube nut. I have found that it doesnt take much more than hand tight to properly torque. Last but not least, it just might be your reg piston. Good luck and dont give up.
Comment
-
maginator
thanks alot guys atually i started out large and went down to the 1 but i dinged it up with the bolt and it leaked slightly so i ordered another one from airgun so i was using the .5 for a while till u guys helped me then i put the new 1 in and its good but the 2 leaks but u know i dont care thats y i buy all day air.Comment

Comment