Need some help with Level 7...

[Ejp414]

I was trying out my old bolt assembly that I am going to sell to my friend who's building a mag. Only problem is that it started leaking out the powertube when I gassed it up. I looked at the exploded view of the classic valve to see what I might be missing (I only have a spring and the old tip, seems like there would be another o-ring in there. Turns out there are two extra things in the exploded view. I just can't figure out what they are and the thing in the middle doesn't look much like a spring, but it's hard to tell from the pic. If anyone can help me out that would be great. Thanks.

Here's the exploded view

[Havoc_online]

1 of those o'rings goes around the the powertube tip. there should only be one o'ring in the tube, then the spacer(older ones were springs) then the tip. make sure everything's in the right order. Have you messed with your trigger rod length(1.98")? might try a new bolt spring.

[Ejp414]

Okay, thanks. I'm missing the first o-ring. If I use one of my spare Level 10 o-rings with the washer, will that work with it?

[Tunaman]

And if you need power tube spacers, I will send you a selection that will replace that old spring. Email me your address.

[Ejp414]

I'll see if my friend wants them, he will e-mail you if he's interested.

[Havoc_online]

no, the level 10 washer and other internals will not cut it. you need the powertube o'ring.

[Ejp414]

okay, thanks for all your help. I guess I need to order one now.