Need info on Minimag front grip...

[Kitsune]

With my old marker I had an expansion chamber in the front and below it would run a line to the bottom of my trigger frame to where the CO2 would screw in...

What would I need to get the same thing to work for a Minimag?

I am not sure if there are expansion chamber, the closes thing I have found is a front grip screw in from www.airgun.com...

But it only has the front grip, what would I need to get a line to run though it so that I can have my CO2 connected through the bottom of my trigger frame (or just frame, don't know what to call it).

Also could someone do me a couple favors...

First, are there any expanssion chambers for the Minimag?
Are there other front grips, if no expansion chambers, for the Minimag and where can I find them?

Also where can I find a list of parts, like barrels, that work with the minimag? Does only AGD supply these items or can I find other sites?

Thanks for the help.

[askman]

what you need to get is the vertical asa for the mag. This screws onto the body rail. On a minimag, it comes with it. You can screw a expansion chamber or gas through onto that. (frankly, if you want to run CO2, I would get a palmer stabilizer) This is a standard screw in asa, so you can use any expansion chamber. unless you got a vertical feed, just about Every barrel manufacturers have barrels for mags. smart parts, J&J, dye, aci.

Check out online stores like www.paintballgear.com www.paintball-online.com for mag stuff.


BTW, unless you are set on using co2, I would recommand High pressure air tank.

[Kitsune]

I know, I know, I am getting high pressure soon, but I am not rich, for all the upgrades I want I will need over $600 and I am in highschool, that money doesn't come easily.

[askman]

check out for sale forum. you can pick up used stuff for about half the price. Also, steel 48/3000 tank is about 60 bucks new.