HELP! My Lvl 7 Valve LEAKS!!!

[Diesel]

Here's my problem... I've got an AGD Lvl 7 valve that's just flat out goin crazy!
First, it was leakin out the barrel... Kinda weird, when I pulled the trigger and held it, it stopped leaking.
so I read up on the board and tried replacing the o-ring in the power tube and I also put a little bit bigger of a spacer in the power tube. Well... it did kinda fix the leak down the barrel, but now the trigger is just going CRAZY!
When I pull the trigger, it shoots, of course. But then I let go of the trigger, and that's when it starts actin weird. Sometimes it shoots again, other times it doesn't do anything, including recharge- and then I can't pull the trigger at all.
I'M LOST! CAN ANYONE PLEASE HELP ME!!!!???????????
Thanks in advance

-Diesel

[BlackVCG]

Try turning up the velocity. Also, did you increase the PT spacer size? You want to put in a smaller size to get rid of the leak down the barrel.

Check to make sure that there is a gap inbetween the trigger rod tip and the back of the trigger when gassed up.

Also, measure your on/off pin. It should be .750" and the grooved end of the pin should point down towards the grip frame.