Level 10: Wont fire!

[GhillieGuy]

I just installed my new level 10, I have a hyperframe set up. There are no leaks now, but it wont fire, when i push in the on off pin on the hole in the back of the frame it is just pressureized... help?

[Tunaman]

crank up the velocity till it clicks...

[GhillieGuy]

Turned it up all the way, also i just noticed there is a verry small leak down the barrel.

[guysdaman]

try a smaller oring carrier you want the bolt to fit snug on the power tube not to tight that it drags and not loose that if you hold it upside down the bolt slides off...just tinker a little until you get it to work right !

[GhillieGuy]

I put the smallest carrier in and it still dont work...

?

[Demobilized]

What spring are you running, and do you have any shims in?

[GhillieGuy]

I have used all of the springs and none work. I have 2 shimes in and iv'e used the smallest carrier and it still leaks, and wont fire.

[pbzmag]

YOu need to up the solinoid power. To change the setting, turn off the HF. Press and hold the power button, while doing that next press and hold the other button. This should get you to the service mode. It should say S5 - 07. Press the top button to level 8 or 9. TO accept the settings, press the bottom button. Changing the service mode setting changes how hard the solinoid pushes. Some HF works with the lvl10 and some do not. I have the same problem and did get it to work, for a little while only. Try changing the service mode to see if that helps.

pbzmag

[GhillieGuy]

It's not the solonoid power becouse when i push the on off pin in from the hole in the back of the frame it is just pressureized and wont fire.

[pbzmag]

Ok, I didn't read that part. My bad. What's your full setup? IE, are you using an adjustable or preset tank? It'll help us more to list what you have on your marker and what they are set at. Also oil up the white oring in the carrier.

[GhillieGuy]

Level 10 set up: Smallest carrier, 2 shimes. I have a preset screw in 68cu 3000psi crossfire tank. Thats basicly it becides the hyper and gas thru set up.

[pbzmag]

Is your tank filled at least 1k? I noticed that when it gets under 1k, the lvl10 starts to drop off. If it is more than 1k, when you turned the velocity all the way up, did you push the sear from the hole?

[GhillieGuy]

What's 1k mean?

[pbzmag]

Originally posted by GhillieGuy
What's 1k mean?

Is it filled up at least 1000 psi.

[GhillieGuy]

Yeah, it is.