How do i stop my trigger from sticking? and Why does my mag leak air out the velocity adjustor sometimes?
-
-
Oil it up where it says OIL on the valve and that should help.
Sig over 50k
-
sounds like dirt in the regulator assembly. Take the regulator assembly apart and clean it. Then reassemble it and lubricate the o-rings as it goes back together.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
Oops, forgot to mention the trigger sticking issue. Clean the on/off assembly.
sounds to me like you may have gotten some dirt in your mag. Either dust or dirt from playing or maybe dirty air/co2.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
Where's the on/offComment
-
check to make sure ur piston is fully tigetened that happened to me and that was my problemMike BuckComment
-
Take the valve out. It's the little brass piece under the valve.
Also, watch the video. It will give you general break down & reassembly steps.
Originally posted by ldser
Where's the on/offComment
-
the vidoe cant rly teach you how to do it i learned from my own mistakes and from my friend who has had a mag for about 2 years now so all u can do it get the diagram from the site and take it apart i feel it helps more than the videoMike BuckComment
-
change the power tube spacer try one lower and one higher and see what it will do (level 7)
good buyers/traders: becercom tunaman pullman richie CoFFeY[NiTrO]
www.vaporworks.net the best bushy upgrades!
www.infowars.com learn the truth about the goverment.
My FeedbackComment
Comment