Warp Need a new Dilithium Matrix

[Strider]

Hehe, couldn't resist...

I have a warp that isn't sensing the vibration from my emag. After playing with it for a while, I think my potentiometer isn't working. Turning it in all different directions makes no difference on how sensitive a love tap is required to get it to spin.

(For reference, I have a working Warp in front of me for settings reference sake)

Is this a part I could pick up at a store and resolder on? Or does this mean I need a whole new board?

Man I wish I had have had this at Skyball...

[askman]

If you have an ohm meter, meter it out to see that pot is the real problem. It could be more serious. If it is just the pot, You will need to know the actual value of the pot. It may not be the pot though. It could be the vibration sensor itself or the logic circuit.

One way around would be to intelli it. get PTP external sensor, or send it into AGD for repair.

[Strider]

Anyone else? Is buying a new board my option? (No I don't want to intelify it)

[Strider]

*nudge*

[ShooterJM]

Don't know. But if you plan on buying another board, I'd probably buy the old one off you. Need to replace an intellified board. Good luck.

[Nobody077]

Shure you already checked but what are your jumper settings? Is it set for use with the vibration sensor? If so then set it for intellie feed and use a small screwdriver in the intellie jack to connect the contacts and see if that will trigger the warp. If it does work on intelliefeed mode then just order the E-mag to warp cable for the AGD store.