Is there any way to shorten the trigger pull on an intelliframe.I don't care how technical it gets
-
I really wish I had my old sig
-
Iv'e heard before thet it is not good to shoten the sear pin on intellies (or any frame)...Sig over 50k
-
There isn't really any way to shorten the pull on an intelliframe that doesn't risk interfearing with the proper functioning of the gun. The full movement is nessasary to insure the sear has proper interaction with the valve's on/off."Relax. Don't worry. Have a Home Brew."
-Charlie Papazian
Feedback: http://www.automags.org/forums/showt...threadid=40134Comment
-
aight thanksI really wish I had my old sigComment
-
i drilled and tapped a hole directly in the frame between the front blot that holds the gun together and the trigger pivot pin, and put a set screw in it to make the trigger only go forward just as much as it needed to to funtion properly.
good luckComment
Comment