trigger stop on intelli

[xen_100]

I noticed there is alot of overpull on the intelli. the point at which the bolt releases and the point where the trigger stops is about 2-3 mm past where it fires. if I pull it really slow, fire, then let it go, it seems to fire correctly. would it hurt anything to put a trigger stop on the trigger to limit this excessive overpull?

[xen_100]

up

[athomas]

Yes, you can put a trigger stop to limit the excessive pull on the trigger. Make sure the stop is adequately past the point where the sear releases the bolt to reduce the possibility of bolt or sear wear and to avoid firing inconsistencies due to wear.

[xen_100]

well I left enough of an error margin to allow it fire reliably. It freakin rip too......very fast.

it has about a 1/4" trigger pull. nice and soft.

[mrbrutal]

If you have your intelliframe wired up to your revvy then you may also want to make sure that the switch in the frame gets pushed down far enough to activate the revvy.

[xen_100]

I dont have it intelli'd. I bought it mostly for the looks and the fact that everybody says it is the best frame for the mag.

but you can just bend the switch arm up to make contact if that was an issue.

[psycoclown414]

i got my intellit for looks also, but i also got it beucase i heard it was a good trigger. i love the pull on my gun, its really nice and smooth. i don't have a problem short stroking either.

[xen_100]

I can short stroke it if I try......but with the LX installed, it just resets.