9v pre-BE agitator vs. 12v revy

[Vex]

Okay, can anyone post (good) pics of their 12v revy taken apart so that I can see the internals (both halves)? I have an old 9v VL 2000 agitator, and I don't see how it's possible to mod it to a 12v X-Board. The battery compartment is too small for one, and for seconds, there's not a circuit board in the darn thing--just an eye and a servo.

Pictures will be most utterly appreciated.
Thanks!

[Vex]

Well, if no one has pics, then has anyone else actually done this?

[lordgroom]

Thismay help. I have not done what you are asking and don't really know how, but I came across this picture earlier.

http://www.automags.org/forums/showthread.php?s=&threadid=73988&perpage=30&pagenumber=1

[Vex]

Thanks lordgroom. Those pics were helpful. I think that my "revy" is just too old to upgrade. That's okay, I want an eVLution 2 anyway. I was just curious as to if I could upgrade my old loader.

Thanks!

[lordgroom]

Are you considering selling the 9 volt? I am looking for a second hopper on my backup gun in case a friend plays.

[Carbon Blue]

Hey LordGroom im selling my 9 volt revolution (been used 3 times)The reason why im selling it is because i need a faster loader for my gun and i want that new evolution 2 . Its in great condition and has always been wrapped in a thick neoprene shroud when playing so the shell has never been hit. Ill sell it for 35$ price is negotiable

[lordgroom]

WOW! $35? People are selling 12V w/Xboards for that price. No thanks. I was think about a thrid of that.

[Carbon Blue]

Originally posted by lordgroom
WOW! $35? People are selling 12V w/Xboards for that price. No thanks. I was think about a thrid of that.

really where!?

[ketel1and7]

IN the past 4 days I have seen 3 for that price.

[Nobody077]

There isint iny room for an x-board mod on the pre BE 9v's. But they are realy easy to intella feed.

[Vex]

Originally posted by Nobody077
There isint iny room for an x-board mod on the pre BE 9v's. But they are realy easy to intella feed.

Really? How? I've only seen the intellifeeding for revys with circuit boards.

[Nobody077]

I will try to open mine up and take a pic for you, but all I did was solder a wire to the positive "on" side of the switch and hooked it too a 3.5mm headphone jack(for my intella wire) and soldered another lead from the jack to the positive tab on the motor in the servo. This way the intella micro switch connects the wires letting all 9volts to the servo. It works great