E-Mag to Warp jumper settings

[TheTramp]

I'm trying to intellifeed my warp from my E-Mag.

I had the correct plug to plug it into the E-Mag board but the wires were cut. I've extend the wires and attached the correct plug to plug it into the Warp.

The problem is that when I plug it in, the Warp runs continuously. I've tried all three positions while the electronics were on and the gun was in e-mode.

1)In the top position it runs all the time.
2)in the middle position it does not run even when I pull the trigger.
3)same as #2 it does not run even when I pull the trigger.

Please let me know what I'm doing wrong and I'll try to answer if I need to clarify anything.

[Dayspring]

If you look at the board with the blue dial towards your knees, it's the bottom two jumpers- one for the sensor and one for the emag pulse. (Just in case the emag pulse dies)