AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026.
Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Can anyone tell me how to remove the Micromag sear and pin? Also, if I replace the AIR valve with an X- or Retro Valve do I need to replace the sear. Anything I should keep in mind? Thanks - Kevin
There's just a little pin that you need to push out. Mine comes out of the left. I replaced my sear because the Retro came w/ a new one but I'm not sure if it's nec.
Comment