LVL 10 + Boomstick

[Mav D MagMan]

Will the Level 10 bolt fit in an average bore Boomstick (I believe they usually come in .688) and if not, would the proper course of action be to sand down the bolt some?(anyone have a proper way to do this?)

I've been in the market for a new barrel for a while and the one I just got doesn't fit with my bolt (go figure) so I'm trying to find something else.

Thanks!
Mav

[dogEmedic]

I got a 14" .689 boomstick that I use on two mags, lx 68 mag and a lx emag with no probs at all, other then a double feed here and their.

Hope that helps a little.

[fire1811]

i have not heard of anyone having a problem until they get
below .687(.687 is fine)

[BunkerRat]

Humm so below .687 wont work on my mag.I just installed the lvl 10 bolt so now my .685 back wont work.Am I reading this correct.Crap!!!

[Mav D MagMan]

Hey thank you!

Mav

P.S. and just to be sure about your bolt fitting, dissassemble your marker and try sliding the bolt into your barrel backs, I'm ordering the barrel over the net so I can't do that!