what should i intelli???!?!?!?!?!?

[DYE-BaLLeR]

which one should i intelli, need input!!

[FooTemps]

hm...either one...I don't think there's an effective way to intelli both...

[n1mr0d]

Originally posted by FooTemps
hm...either one...I don't think there's an effective way to intelli both...

slap a relay on there.....and have the warp run off it's 9v battery so you don't have to worry about the warp getting overvolted......

you would just wire the relay up in parallel with the intellifeed revvy, and have the normally open contacts wired up in the warp firing thing.....grrr can't think straight. any electronics guru's wanna explain more?

[[M@g_D@ddy]]

umm, i would do just the revvy because the warp can keep up w/ u, the revvy may or may not have a hard time

[DYE-BaLLeR]

thats good cuz my revi is alrdy intellid

[Shaft]

The Warp.
The warp acts as a buffer between the needs of the gun vs the supply of the revvy. Unless you fire strings of shots that exceed the amount of buffer in the warp the revvy will work fine.

I don't rely on the vibration sensor.

[Miscue]

Just do the warp. You can do the revy as well if you want, but I think that's a bit excessive.

[PigSweat]

Does anyone have directions to Intellifeed a warp?

[Shaft]

There's nothing to it. It's the same as the Revvie on the gun side.
Then plug it in the jack on the warp.

[PigSweat]

Oh! Stupid question, I guess. Didn't know the wapr had an intellifeed jack.

[emanjamin]

Well, I chose both.
I had a link on how to do this and what ended up happening was when ever the the eye in the rev did not see anything, the warp would spin automatically. BlackVCG said something in the setup would have a voltage leak but it doesn't matter for me, because the warp won't spin for I always have paint in it and it will spin anyway when I shoot so it doesn't effect me
If the revy is spinning with no paint in it then the warp should also be spinning because of the leakage.

[n1mr0d]

Originally posted by emanjamin
Well, I chose both.
I had a link on how to do this and what ended up happening was when ever the the eye in the rev did not see anything, the warp would spin automatically. BlackVCG said something in the setup would have a voltage leak but it doesn't matter for me, because the warp won't spin for I always have paint in it and it will spin anyway when I shoot so it doesn't effect me
If the revy is spinning with no paint in it then the warp should also be spinning because of the leakage.

doin that wouldn't be too hard. just connect a relay in parallel with the eye, and the link to the warp to the normally closed contacts on the relay....whenever the eye circuit is closed, the warp would be off, when it the eye circuit is open, the warp would be turned on.

[emanjamin]

Originally posted by n1mr0d


doin that wouldn't be too hard. just connect a relay in parallel with the eye, and the link to the warp to the normally closed contacts on the relay....whenever the eye circuit is closed, the warp would be off, when it the eye circuit is open, the warp would be turned on.

Ok, I don't know what you just said, When the eye circuit has nothing blocking it, as in no paint the warp will spin. When there is paint present the warp won't spin. What kind of relay should I look for. I can hook up a relay but the only thing is then my warp would be affixed to the hopper because of the wiring. Maybe I could do a infrared thing or something....
I have a lot of wires in my mag setup already, and I don't really wan't any more if possible.