Retro Valve Problems...

[Straylight]

I just bought an Automag with a Retro-Valve... the problem is that it dont work.

I can fire once, then I have to wait a second or two before I can shoot again... what's wrong???

[BlackVCG]

Tighten the velocity adjuster screw one full turn and see if it shoots better. Otherwise, make sure the sear is able to pivot freely and that the valve is oiled.

[Straylight]

I have tried to change the velocity, and it doesn't help

It works fine with the standard valve

[Straylight]

I have tried all of the above, and it dosen't help

[Cha0tic]

what kind of tank are you using? what is the input pressure?

[Straylight]

I have a PMI Pure Energy 3000PSI Preset, 800psi I think...

[freakyt]

What is your Air system? MicroLine?

Do you have a any other regs on your gun besides the tank one?

[Straylight]

I have microline, and no other regs...

One thing I'd like to mention: If I gas up the gun, and then removes the air again, and opens the valve, the o-ring that goes into the backsection is sitting in the metal cup that sits between the two parts, is it supposed to do this?

[Straylight]

The problem is that it takes the valve almost 1 sec to charge...

[technogeek]

I ran into a similar problem with my RT/Pro (similar valve) In my case it was the elbow I was using. The fitting extended into the elbow too far and blocked off the airflow. A quick trip to the vise and a little work with a hacksaw cured the problem. Might be worth a look depending on your setup.