My level 10 power tube tip sheared off clean,right at the groove where the power tube o ring sits.I have no idea what could have caused this as it was only hand tightened.Is this a common problem that i should worry about or just a freak defect?This happened after only two cases of paint were shot through the gun.
-
-
O have only seen that 1 other time in a Lvl 7 tip, Its just one of those weird things that happens.
-RobertServing AGD customers since 93, wishing I could beat some common since into some of them about 5 hrs later.
MCB Feedback +35 --+-- Automags.Org Feedback +25 --+-- PBNation Feedback +24 -
I too have seen it happen because the guy forgot to put the rubber bumper back on, so the bolt had no cushioning when it came back and hit the valve body. You can probably take a easy out and get it out.Purple CnC X-mag XT00176
Excellent Traders--mh53eplt--Gadget68--Jimmi9999--swerp
MSTS Series Alaska 5-12-03
1st 5-man
2nd & 3rd 3-man
MSTS Series Alaska 7-12-03
2nd 5-man
1st 3-man
MSTS Series Alaska 8-23-03
1st 3-man
3rd 5-manComment
-
This is something that AGD should get fixed up for ya without a problem.
Later ~ DaveDavid M. Jones
AO Member #1111 - Formerly davej946
Member of Team AO, MGO 2003
Wildfire :: Division III X-Ball
www.wildfirepaintball.com
Supported by:
Wildfire Paintball
Nelson PaintballsComment
Comment