Pic please .. converter HL HR to centerfeed

[edwards888]

I have searched and searched to no avail. Does anyone have a pic of a HL HR barrel that has been milled to centerfeed?
And...
Will the HL HR slots still be available for use or does the new milling cancel those out?
Thanks for the help!

[athomas]

Usually HL and HR barrels use the same slot. A twist in one direction locks its left and a twist in the other direction locks it right. To convert to a center feed, all you have to do is drill a detent into the center of the T slot where the barrel is oriented with the breach hole straight up.

Some barrels use different slots for HL or HR. You have to check to see if one of the slots will allow the breach to be straight up. Drill the detent hole to lock it in this position for center feed.