CA adapter removal

[Wickster]

I just put a drop forward on my mag and ran braided ss from the valve to the drop forward. I wanted to remove the ca adapter since I don't need it there now, but the ?hex screws? were in really tight. So tight I was afraid to apply more pressure for fear of breaking something. Is it possible to remove them? Do I just need to use a pliers on the hex key?

Thanks in advance for the help.

[Demobilized]

Maybe you are turning the wrong way . Also I seriosuly doubt you will be able to break anything, but im not sure.

[nippinout]

Yeah, make sure you're turning the correct way.

What you can do is try running the part under some hot water or a hair dryer on it's lowest heat setting. Don't let it overheat.

If it is using some sort of thread lock, this can help loosen it up.