So I am trying to install the power tube tip. I can't get my power tube tip unscrewed. Anyone have any clue as to why? I tried with a quarter..tried with a nickel...even tried heating it up with a lighter...
--Lord1234
--Lord1234
-
A Sanchez Machine Distributor
Ask me about my US Armed Forces, Law Enforcement and Fire Department Discount
PBN Feedback
AO feedback
EBAY feedback -
I use a Dime. lol
If that dosn't work, put the valve in a vice(not so tight that it will fugg the valve tho) and get a pair of pliers or something.Classic RT - RT02667
Blade IntelliFrame
Dye Ultralight
http://TheHybrid.net/ -
-
Vice grips on the nickel, and the valve in a vice (wrap it in rubber or something to protect it). I bet that would get it off!
Basically, combine the two previous ideas.
Later ~ DaveDavid M. Jones
AO Member #1111 - Formerly davej946
Member of Team AO, MGO 2003
Wildfire :: Division III X-Ball
www.wildfirepaintball.com
Supported by:
Wildfire Paintball
Nelson PaintballsComment
-
get a screw driver
good buyers/traders: becercom tunaman pullman richie CoFFeY[NiTrO]
www.vaporworks.net the best bushy upgrades!
www.infowars.com learn the truth about the goverment.
My FeedbackComment
-
why does everyone have it backwards??
you put the quarter in the vice(who cares if you scratch that?) and you use the mass of the valve to do the work. with the quarter in the vice, you take the valve and put the groove on the quarter and twist firmly by hand and the mass of the valve will break that seal. it will come apart so nice you wont believe it!Comment
-
I used to use an allen wrench side ways for leverageComment
Comment