Intelliframe Problems...

[mrkbik]

I recently bought an intelliframe. I got all the right parts from Radio Shack and hooked up the intellifeed. When I tested to see if it worked, I plugged in the male end and female end and turned the revvie on. The propellers in the hopper just kept spinning until I unplugged the wires or turned it off. Anytime I turn the revvie on, it just keeps spinning. I had paint in the hopper so I am sure that the eye was blocked. I then checked inside the grip frame to see if the switch was being held down, it was not. I don't know what do do. Can someone please help me?

[rehme]

sounds like one of the wires in the switch is touching the other one make sure you put some black tape around each one of the wires by the switch because if they touch they are making a cicuit and that is what is causing the 12v to keep spinning

[wimag]

i am gonna assume you wired it correctly. check the position of the micro-switch. make sure i is not too far back which keeps the switch open and runs the loader full time.

[mrkbik]

Problem solved, thanks guys.

[lordgroom]

So, what was the problem and how did you solve it?

[mrkbik]

The electrical tape on the wires attached to the switch had come undone and the different wires were touching. I just retaped the wires and it worked perfectly.