Hi, i have a huge problem with my micromag valve, and i don't know whats wrong. When i screw my tank in the nitro comes out of the little hole in the back of the valve. I really don't know what is wrong. I tried replacing the o-rings on the on/off and it did nothing, i was hoping someone could help me out on this, otherwise i am gonna have to buy a new valve. Thanks
-
-
turn down the velocity....(to the left)...lets see if that helps...mags vent out the back when the velocity is > 340 fps
-alf -
if that doesn't do it then call AGD and tell them you need a new reg piston. they don't cost too much and it sounds like yours may be done.MicroMag Phase 1
S/N GFX001489
AutoResponce frame
double trigger shoe (until i can make a ring shoe)
PTP warp feed
And the Biggest, Heaviest, 19+bps'ist Tippmann you have ever seen.
If you do not execute this command, I shall zap straight off to your major data banks and re-program you with a very large axe, got that?
There must have been a time
when we could have said no.Comment
-
my friend said it could be the reg seat or possibly a problem with the o-rings in the valve. When i first got it( i bought it used) i couldn't screw in the tank when it was on medium velocity, if i did it would leak like crazy, i would have to bring the velocity all the way down and slowly bring it up after the tank was on, what do you guys think?Comment
-
that's a tough one Eclipse. could be your reg seat, or your piston. I'd say get a parts kit and replace all the soft parts first, then if it still happens replace the piston.MicroMag Phase 1
S/N GFX001489
AutoResponce frame
double trigger shoe (until i can make a ring shoe)
PTP warp feed
And the Biggest, Heaviest, 19+bps'ist Tippmann you have ever seen.
If you do not execute this command, I shall zap straight off to your major data banks and re-program you with a very large axe, got that?
There must have been a time
when we could have said no.Comment
-
rear valve leak
ElementEclipse,
my old p/f mag used to do that. My fix for the leak was to remove the internals and do a complete cleaning. Then repack and oil. Sometimes dirt or small particles get caught near the spring pack in the smallest of places and cause a seal break. Try it before you replace all the seals. It could be a simple fix.Comment
-
yeah, i brought it into metal shop today and cleaned it, wow it was filthy, i don't think the kid ever cleaned it or re-placed the o-rings. So i cleaned it andmy friend took it home( he knows about 100 times more then i do about them) so he is gonna get me a parts kit, re-place the o-rings, and he said everything should be fine. He said the original problem was probably that the o-rings were plastic and not rubber. thanks a lot for your help guys, i appreciate it.Comment
Comment