Warp Problem.

[Blak Magic]

Hey,

I own a AGD warp and i got a pro team products 12v hookup thing. And whenever I plug it in and use 2 batteries it never ever stops spinning. Ive tried messing with my dwell it just spins non stop.

Any ideas?

[askman]

When I did my 12v mod to my warp, I had to add .1uf(microfarad) cap to the output of the regulator. I did it by soldering the cap to the vcc and gnd of the warp control board. this solved problem of it being on all the time. basically, the cap act to keep the voltage constant and keep it from fluctuating...

[BlackVCG]

Turn down the blue potentiometer (turn it CCW).

[Blak Magic]

I already tried messing with that..

[Dayspring]

You've got noise in the line. The warp motor senses that as vibration and activates. I had the same problem when I had somebody try and 12V my warp. It would run constantly. You need to slip a capacitor or two in the lines. If you check out RobAGD's site, you can see the wiring diagram for it.

https://www.robagd.com

[Blak Magic]

I made it so it doesnt sence vibration anymore by removing a little clip thingy.

[Blak Magic]

no one knows why it never stops spinnnnnnning?

[BlackVCG]

Did you read Dayspring's post?

[Dayspring]

Gonna bet no. Remember though- I belittle EVERYONE I meet. He must have heard from SOMEONE on the boards.