x valve problems. PLEASE HELP!!!!!!

[maglover52]

i am having troubles. i have an air america me'lee 88/3000psi preset at 800 output presure. i have a pic of my gun posted below. when i gas it up it will either
(A)shoot nonstop until you degas it
(B)shoot once then leak air out the barrel
(C)just leak air out the barrel

i have the second smallest power tube spacer in. the one dot no grooves. i have the velocity up as high as it will go. and it is doing the same thing. please help me. and please no flaming this is very annoying that it isnt working for me.

[maglover52]

other side....

[Snertz]

Is the lvl 10 setup correctly? Since I read somewhere that they were installed on the valves but not setup. Also, what happened if you hold the trigger in?

[maglover52]

thats what i think is the lvl 10 istn setup right yet. and no they dont come set up.

[_Spork_1]

for A) shooting uncotrolably, does it start shooting with out you pulling the trigger?

[maglover52]

yes

[Russ]

I know you've been having trouble with this for a while...Have you followed the instructions on the CD?

Kinda sounds like the sear isn't catching the bolt. is your sear in good condition?

My suggestion is to send the gun to AGD (or one of his Elves) for a tune-up.

Good Luck

[maglover52]

i have done everything the cd said. and would it cost me any money to send it in to AGD?

[Russ]

maglover52,

You've been messin' with that thing for over a week. It doesn't work. you've spent a small fortune on upgrades. It doesn't work. put it in a box, and send it to someone who can find out what's wrong...priceless :)

[cphilip]

Runnaway is the sear not catching properly on the bolt. The Sear and the on off pin are parts of that equation as well as the Bolt spring. You realy need to measure that On Off pin and make sure its not the wrong size.

Tell me what spring you have in there by the way...

[maglover52]

well im at my grandmas so i cant measure it right now. but how big is it supposed to be? it only came with one pic. and i have the medieum spring in it. i can't work on it anymore today my bro took his mag body and rail away from me because hes a poo face and my new ule body and omega body rail arent here yet.

[cphilip]

Read this: http://www.automags.org/forums/showt...threadid=67604

[maglover52]

its about 3 quarters of an inch.

[Blazestorm]

You have to find exactly how big it is

they only differ by .01 of an inch or so

[cledford]

We need to know how many shims are installed for LX also. (Or in this case possible lack there of...)

To measure the on/off you'll need precision calipers. The lenths are very precise and only vary by a few thous per type of gun.

Also, are you triple regging the gun?!? It looks like a preset (assume HP at ~800) a vertical reg, then the X valve?

-Calvin