Need a cradle that will fit my Nitro tank

[Newbie]

I recently bought a Mac Development 68ci 3000psi nitro bottle with a Max Attack Regulator on it. I went to 888paintball to get their largest cradle (the Empire gladiator cradle), but my bottle and regulator is too big for the cradle to go around, except for the neck of the bottle. If I install it at the neck, my bottle is too wide to fit the dropforward part of the 2 piece cradle.

Bottle Measurements:
from center line of bottle to outside: approx. 2 inches
circumference of bottle: approx. 13 inches
neck of bottle: approx. 4 inches

Regulator Measurements:
circumference: approx. 4.5 inches
length: approx. 2.5 inches

ANY SUGGESTIONS ON WHAT BRAND OF CRADLE TO BUY AND WHERE WOULD BE GREATLY APPRECIATED.

[tye92]

Cradle suggestion

I have a 114ci 4500psi tank, the big tank and i had the same problem until i tried a KAPP drop zone III nice setup, goes around my centerflag reg w/o any problem cuts it close but it fits even my beastly tank. It only leaves about 4-5" from the back of my gun for me to shoulder which gives me a nice tight setup. It can be found almost anywhere.
Tye