E-mag triggers problems

[Warewolf50]

Ok here are the problems, first of all the screw in the middle of thre trigger is stripped, so i need to take the trigger off so i can get the screw out and replace it.

2nd problem is when i put the battery on my gun the normal sdisplay comes up then all the words just turn into weird looking giberish things. But when the batery is low on power it dosent do that.

So my first question is how do I get my trig off, read that the trig is removed from the right side, so when i push on the left side it wont budge. And my next question is what is wrong with my gun when I turn it on.

[Dayspring]

Try pushing the trigger pin out from the other side

And as for the garbled text- the magnet's too close and it messing with the board. You have to back the trigger magnet out. (Which for you is an issue cuz the screw for that is stripped.)

[Warewolf50]

I haved tried pushing from both sides and the dang thing wont budge. How can i get it out.

[rehme]

well on my retro mag (dont know if this works for a emag) but i just got a small allen wrench that fitted the little circle area holding the trigger in and hit it with a hammer to knock it out of place like i said i dont know if this works for a emag tho

[Russ]

I haved tried pushing from both sides and the dang thing wont budge. How can i get it out.

You need a quality, 1/8" drive-pin punch, and a hammer (I prefer a 10oz ball-peen hammer)

Set the frame on a block of wood, with a hole in it (a place for the pin to be driven into) Bang from the right side (while the gun is in your hand). The pin is tight. It takes some skill and know-how to do it right, and not damage the frame.

Good luck

[Warewolf50]

Ok I got the trig out and got a new one, but about the garbled text, when i backed the magnet out the same thing was happenin. My battery is extremly low, is that a possible prob? Any help would be great. Thanks.

[Warewolf50]

ok i charged my battery and i am still getting the garbled text with the trig mag backed al the way out, or i will get a very faint outline of the opening text when u turn on the e-mag.

But the majority of the time when i power up the gun the garbled text comes up. I really have no idea how to fix this, other than sending it into agd. Any help would ne greatly appreciated.

[Frank (the spank)]

Hmm...

My new, never been shot mag was doing the garbled text thing.. I charged the battery and it apears to have fixed it.

Try draining your battery ALL the way and then charge it overnight, see what that does.

[.bolink]

When My mag was short circuiting...it would do that garbled text thing. I thought my mag was talking to me in Hebrew or some junk. Fixed the open wire and its fine now. Try draining it completly as someone else suggested.