Emag frame/trigger help

[E==Mag MAN]

Well today at the very end of the day the magnet that is in the trigger popped out and it just sits attached to the top of the frame and leaves my trigger limp. First off before I go and start pulling stuff out, to take the trigger out I push out the silver pin on the side of the trigger frame right?

Also can I just use some kind of super glue or is there something specific that I should use to glue that magnet back in with?

[ChucktheMAGician]

Yeah, I think most pins push out from right to left, mine did(pushing from the pull pin side). It's in there pretty good so you'll need a punch and a hammer. Not sure about super glue but that's what I'd try if it were me. I have a double trigger you can buy if you can't fix yours!

[E==Mag MAN]

Thanks, I think i will fix my trigger instead of buy one from you... but thanks.

Anyone else on the glue question?