Emag gas leaking

[stockguy13]

No real problems with the marker, except that there was an almost constant leak out of the velocity adjuster key hole at the back of the gun - I have two questions 1) What would cause this and 2) if there was too much pressure to cause the leak, how can I increase velocity and reduce the pressure???

still learning

A//

[Russ]

Please tell us your set-up, so we may better help you.

[BlackVCG]

I'm assuming your running Level 10 and it's leaking out the back before you get to your desired velocity?

If that's the case, you need a new piston. The new pistons from AGD are preset to a higher blow-off pressure. Call the tech line, tell them the problem and make sure that you can get one of the new pistons with the higher blow-off.

If you have Level 7, just decrease your velocity until it stops leaking. It shouldn't leak until you get to around 400fps.

[stockguy13]

of course, I am running an Emag, level 10, 3000 psi preset to 800 psi. There appears to be an almost constant leak, but it becomes worse after around 260 FPS - at lower velocities, the leaking stops after I shoot a few times and then starts again, seemingly random. Again, at 260 + FPS the leak is almost constant..

[Jonesie]

Follow Black's advice. He hit the nail on the head!

Dave