problems with pin valve..

[SoupRman]

i was screwign my tank in my gun when i noticed that my d/f asa was in the on position. but it was too late. so no air was coming to my gun. so i unscrew it and see that the part that pushes down the pin valve is in the tank pushign down the pin valve. so i clampt hat part and pull them apart. all the air leaks out and the pinvalve is some how stuck down. Check pics for more details.

so i switched to co2, mad air leaks out the back, shooting hot, turn down vel. still leaking out the back. go back, take otu valve nothign wrong. put back together screw in tank.. now the gun won't shoot. so i take out the valve and some on/off parts are missing, check pics..

so what i wanna know is for the n2 is there a way i can pull it out? and for the automag valve, is it just the on/off assembly that is messing up?

pics of valve and assembly

[Thordic]

Just a quick note...

Looking at that picture of your on/off assembly, I don't see the on/off top. It's a little brass widget that should be between the stainless steel part of the on/off and those loose orings you have there hanging on the on/off pin.

If you are missing that, then I could definitely understand why your gun is leaking

To describe it a little better, its a carved down brass cylinder a few millimeters thick, the width as the on/off SS backpiece. It has a hole in the middle for the on/off pin, and you can tell its made for air to flow through.

[SoupRman]

yeah, i knew that would catch your eye. hmm... time to call up joann.. if i remember her extension # right