can't pull trigger with lx kit

[tazman]

I had my lx kit installed at skyball but I had no air to test it there with. Now that I finally got my tank filled I went to try it out but I can't pull the trigger? Can any one help me out?

[Paintmanmike]

Can it be pulled without air? No mechanical stopage? If so it sounds like the seal in the regulator maybe gone, if that leaks full tank pressure is applied to the on-off making trigger pull very difficult.

Check the Official Lvl 10 problem thread for other ideas, and if worse comes to worse get ahold of AGD, a phone call to them can work wonders.

[tazman]

It can be pulled fine with out air and it gases up okay but after that I can't pull it. It doesn't leak all I need to know is what way to go with the spacers larger or smaller

[Paintmanmike]

Typically you start with the install with the largest (3 lines in my kit) and work your way down to the point when you have the largest that does not leak. The idea is that if you go back to the next larger one it leaks.

Post your current setup that will help. Also look at the Offical Lvl 10 Problem Thread, its a wealth of info.