Okay I have a black teflon Hopper left body for my Emag, and my x-valve I got in a trade won't fit in it. Anything I can do? Can I send it to AGD and they install it, or possiblly trade out the body?
Chris Geiger
Chris Geiger
-
What exactly do you mean it won't fit? Where won't it fit? Is it rubbing somewhere? Does it take some pressure to fit?
Please give additional info. -
Sorry been along night man,
The bolt is a larger diameter then the body. With out the bolt it all fits fine, but add the bolt, and itwon't go in all the way.
It is like the bolt is to larger, not by much.
chrisComment
-
There might be a burr in the body that is holding the bolt up. Get a wooden dowl? rod and wrap some medium grit sandpaper around it. Try putting the bolt in and seeing where it is held up at. Try not to remove to much material but use the sandpaper to either smooth out the burr or remove enoght material that the bolt fits. This is not uncommon so don't worry too much.Comment
-
thanks, I will give that a try
chrisComment
-
Good luck and be careful.Comment
-
You need a REVERSE x-valve with a hopper left body, go onto airgun.com like your gonna order the x-valve, at the bottom it will tell you a couple things, one of them is that if you have a hopper left you need a reverse valve. hope it helps.Comment
-
Just file out the hole in the body washer that separates the front and rear of the body. There may be a burr or it may be off center for some reason. Filing inside the hole should fix it.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
how is where the air inlet hole is positioned going to help his bolt fit?Originally posted by jcoolzer0
You need a REVERSE x-valve with a hopper left body, go onto airgun.com like your gonna order the x-valve, at the bottom it will tell you a couple things, one of them is that if you have a hopper left you need a reverse valve. hope it helps.
sometimes I dont get peoples logic at all.
"super multi-green mag" Cp barrels, LX bolt, no-rise, intelli, 47ci flatline, halo................
Red dragun body, turbo valve, 12" Boomstick, Spud magics anti-chop bolt with quickstrip, ELCD, nitroduck 68CI,Gas thru stock, 12V revy, AGD Warpfeed system
Xen's paintball pagesComment
-
thank you Xen, I was thinking the samething!!
chrisComment
-
call AGD
good buyers/traders: becercom tunaman pullman richie CoFFeY[NiTrO]
www.vaporworks.net the best bushy upgrades!
www.infowars.com learn the truth about the goverment.
My FeedbackComment
-
Judges?
WRONG...
Originally posted by jcoolzer0
You need a REVERSE x-valve with a hopper left body, go onto airgun.com like your gonna order the x-valve, at the bottom it will tell you a couple things, one of them is that if you have a hopper left you need a reverse valve. hope it helps.Comment
Comment