any one know how to shorten intelli trigger pull

[jcoolzer0]

i was just wondering if any one knows any ways to shorten the trigger pull on the intelli frame.

[rikkter]

there isnt actually a way to 'shorten' a trigger pull in a mag. no matter what frame, the trigger rod has to be pushed a certain length for it to push the on off pin and release the bolt. you could lengthen the rod so its already in the process of doing those steps at rest, but it just wears away parts quicker and isn't good for the gun.

[xen_100]

I just put a trigger stop on mine. I noticed there was about 1-1.5mm of overpull on the frame after the gun fired. the trigger stop kept that from happening.

[johnny dee]

how would u accoplish a triggr stop...i hear about them but nobody ever says how to do them, and i want to do one to my gun. xen how did u do urs

[xen_100]

on the intelli there are two way....the easy way and the not so easy way.

the not so easy way:

drill and tap your body rail for 4-40 threads right over where the trigger is. if you look how the trigger moves, there is a spot in there that moves up towards the rail each time you pull the trigger. you put a stop right there and it will hit the trigger and stop its movement. the hard part is getting the spot on the rail just right and you have to take the grip off each time to adjust it until you get it right......once it is set, it is set, but the adjustment period would be a pain. the advantage is it if totally clean........no-one would even know you had a trigger stop.

the easy way:

punch out the pin that holds the trigger in. drill and tap the trigger for 4-40 threads, reinstall the trigger and adjust. much easier, but you can see the stop, so it is not quite as clean. both ways work very well.