automag on/off

[kiwi n0ddy]

just wondering if there is a diagram or anything that explains how the automag on/off works..

this thing is impossible...

especially when i turn the brass piece upside down and my mag turns full auto(complete cycles)..

cheers
nods
Damage Inc NZ

https://www.titaniumpaintball.com

[xen_100]

is this an RT valve or a classic valve?

they both work essentially the same. the pin goes into the center oring and stops airflow when closed. when you let go of the trigger it opens and lets air into the dump chamber.

if you are having full auto problems, then you have a worn bolt or worn sear. check those. the on/off should not effect that. if you have a RT style valve, you reactivity is too high, turn your input pressure down.

[kiwi n0ddy]

classic..
dump chamber???

when the trigger is not pulled.. it would seem that air can flow straight out the end of the valve to the bolt, if the pin is not sealing off the oring.??

its only when i turn the brass piece upside down in the on/off..

not that i want it do this.. im just wondering why it does...

[xen_100]

dont know.......but as long as you dont put it in upside down, it works fine?

[Nobody077]

http://www.airgun.com/downloads/valveexplodedview.pdf

Thats a link for AGD's breakdown for a classic valve.