X-Valve is leaking air...

[Lord_Whoopass]

I just got my x-valve for my mag and the first couple times i used it the valve was fine, i oiled it after each use with kermode oil. Well now it started spiking velocity: one shot is normal and the other pretty much went maybe 5 feet. Now when i put air to it the air leaks out the hole by the on/off part of the valve(middle part of the valve). I figure its an O-ring but i am not sure. If someone would tell me what it is and how to fix it(how to get to it) I would be most grateful.

[xen_100]

if it is leaking out of the on/off then take the valve out of the gun.

look at the bottom. there should be a little square brass thing with a pin in the middle pull that whole assembly out and replace the o-rings in it. you might even be able to take the pin out and oil everything and have it work again.

[BajaBoy]

ok gas it up and hold the trigger in? still leaking? oil your on/off crap... if it is stil leaking then it might be your reg.

you shold not have to replace oring this soon

[xen_100]

"shouldn't" is the operative word........there could be a defective o-ring in there......if oiling it doesn't help, then he will have to replace the o-rings.

[Lord_Whoopass]

When I hold the trigger it leaks out the barrel... and I pulled the brass out and oiled it and it still leaks..

[xen_100]

well sounds like you need some new o-rings.

[Lord_Whoopass]

Just the oring in that brass square in the bottom need to be replaced to fix it?

[xen_100]

depends where it is leaking from.

if it is leaking down the barrel, then o-rings in the top of the on/off need replacing. (the ones that are in the RT valve at the top of the on/off chamber.

if it is leaking outside of the on/off, then the two o-rings in the on/off bottom need to be replaced.