hyperframe and X-valve???

[mini_marc_mag]

I have a minimag with hyperframe, and I was wondering what does a retro valve or x-valve do dirrerent then the minimag valve... because I know on a R/T you have the little pin in the back of your trigger that pushes back your trigger into youre fingers but you cant put that on a electric trigger so what will it do to my gun if I have a electronic trigger????

[Dayspring]

The pin that pushes the trigger back is on all AGD guns. It's how they work. The on/off pin pushes down on the sear and releases the bolt. When the sear locks back down on the bolt, the trigger rod pushes the trigger back to firing position. The RT just does it faster & harder.

Since you already have the Hyperframe on the gun, all you do is put the X-valve in and you start rocking. (Keep the on/off pin you are using however.)

[hostage]

just one thing to keep in mind, if you go retro or x-valve, make sure to change the oring inside the on/off cavity to a teflon, or it will not work.
-Doron

[felony]

I know this is an old post..

Just wondering how the x-valve and hyperframe are doing?

Is it worth it? Is it good? Give me some info .. anything you can..

I want electro, but I want my mag. I have put too much into my mag to sell it for a electro, so I am just wondering if it is worth it on my x-valved mag?

Any info is appreciated. Can I buy them off-line, would you suggest buying used?

thanks alot

Dan