Hey, on one side of my empire on/off valve it leaks where the allen screw goes in...can anyone help me with fixing this, i put teflon tape on it and it just slows the leaks, thanks
-
aim-daunfergedable
[email protected]
good traders - jadedt, JAM, sellout007, jon/xpm, keyser_soze
ao feedback - http://www.automags.org/forums/showt...threadid=78918
PBNation feedback - http://www.pbnation.com/showthread.p...hreadid=249826 -
I'm assuming you have a little plug and than macroline on both sides.
Put teflon around the threading... a good amount... not a WHOLE lot, and make sure its JUST on the threading... now tighten the end plug a lot and the macroline just so its tight but not overtightened.
It shouldn't leakMy Feedback
UBLPB. UBLPB. UBLPB.
-
there is no leak whatsoever on the side with the macroline elbow. the other side where there is nothing, just an allen wrench screw has the problem with leaking. i put a good deal of teflon tape but it still leaks. would locktite work in this situation???
aim-daunfergedable
[email protected]
good traders - jadedt, JAM, sellout007, jon/xpm, keyser_soze
ao feedback - http://www.automags.org/forums/showt...threadid=78918
PBNation feedback - http://www.pbnation.com/showthread.p...hreadid=249826Comment
-
Comment