Just tell them you need the spacer for the ZGRIP, with the .25" inside diameter hole for the rail bushing. Real sorry...suppose I should have checked it first. I won't make that mistake again.
-
-
thanks a trillion. does the z-grip spacer have the same outside diameter as the rt benchmark though?Comment
-
I believe the hole in the RT ZGrip Frame and the RT Benchmark are the same. I am coming up with frame hole size of .355 or so.Comment
-
they almost work...but they're a bit too short and just a bit to wide in the inner diameter. Hey man I tried
Hmm it's very odd that AGD would screw up here......
Taking mags apart is fun, its even more fun when you don't know what you're doingComment
-
ok i am sure they probably would have the same outside because of the whole bajo bolt thing. ok then I can't thank you enough for all the help you have been.Ups for Tunaman!!!Comment
-
I ALSO EMAILED THIS TO YOU (SORRY IF IN CAPS)
UNFORTUNATELY, WE DON'T MAKE SPACERS FOR BENCHMARK FRAMES. HOWEVER, i RECOMMEND TAKING THE RAIL BSHING (MUST REMOVE IT FROM THE RAIL OF COURSE) AND GRINDING IT DOWN SO THAT IT FITS THE RAIL PERFECTLY WITHOUT ANY EXTRUSION FROM THE BUSHING. THIS WILL WORK. AS FOR THE POWERFEED PLUG, I WOULD NEED YOU TO SEND ME
YOUR SERIAL NUMBER
NAME
ADDRESS
PHONE
EMAIL WRITTEN OUT
AND SAY YOU WANT A PARABOLIC POWERFEED PLUG
TILL THEN
JON
SORRY THIS IS IN CAPS, IT WAS CUT AND PASTED FROM MY EMAILComment
Comment