What hose would i need to put a messiah reg on an RT pro?

[trutle]

(I am MSpaint master!).
What kind of hose would i need to do that to My RT Pro, were would those hoses go, and finally would i need any special adapters for those hoses.

Feel free to draw it out as i have :).
(infact that would help a considerable amount if you can't post the pic email me the pic {make sure it's jpg} at [email protected])

[Miscue]

You would be triple regging your gun... not good.

[trutle]

oh, so there already 2 regs in the RT?

so how would i do this using a gas thru grip, this there away to turn that foregrip into a gas thru grip

[johnny dee]

as miscue said, tripple reggign your gun isnt good. As for a gas-through, u dont nessiceraly need on on a mag, u jsutneed a foregrip. i run my line right from my asa into the valve on the gun and its fine. tripple regging your gun is going to starve it for air.

[trutle]

I know that, i have gas thru (it comes on the gun) but i want to put a massive cradle on my gun to center it with my 90ci and i need to know how to route the gas thru the gun because the hose it come with (the one that runs from the back of the gun to the asa) doesnt fit!

[johnny dee]

how big of a cradle are u putting on your gun, as far asline goes, try a longer peice of steel braided hose, or macroline.

[trutle]

it's a cradle off a ans gxe 4 which can be seen here so it's pretty big, but you answered my question before about what kind of line i needed, thanks for clearing up the stuff about triple regging.

[rtslave]

I have seen some foregrips in the fourms that were made to be a gas throughs (RTp isn't)by drilling and tapping, I've also seen people put an old school RT foregrip on an RTp just look around, if I see one I'll tell you were is is. I run a dropzone on my RTp with a flatline and I use a full piece of macroline. [IMG]rtp2[/IMG]