So yeah.. Just noticed the power tube tip o-ring isn't included inside of the parts kit.. Which o-ring would i use for that? Also, whats the best way to get the two little o-rings out beneath the on/off pin assembly?
thanks!
rob
thanks!
rob
-
PBN Feedback AO Feedback eBay Feedback
DIRTY ROTTEN SCOUNDRELS (Rob Kenny and Matt Bradley) LIVE @ www.djinnuendo.com TUES 2/8 - 8 to 10PM -
I don't have a mag handy to check, but for some reason I'm thinking the power tube tip o-ring is the same as the larger diameter o-rings inside the on/off assembly.
As for removing o-rings from inside the on/off assembly, careful use of a dental pick is my preferred method. If a dental pick is not available, an appropriately bent paper clip or even a wooden toothpick may get the job done. You might even be able to lever the rings out using the on/off pin by itself.
BJJB -
Thanks. I will try that. Well I went through the kit just to check the extra O-Rings I had to see if one would fit but the ones close in size we a little too big.. The I replaced all the other rings, though. The power tip ring didn't look too bad so I'll leave it for now until I can find some that fit properly. I can't gas up my marker for another week or so,when my hoses/elbows come in but I will work on getting the On/Off rings out for now
Thanks for the info!
-Rob
PBN Feedback AO Feedback eBay Feedback
DIRTY ROTTEN SCOUNDRELS (Rob Kenny and Matt Bradley) LIVE @ www.djinnuendo.com TUES 2/8 - 8 to 10PMComment
Comment