How heavy is a 114 ci nitro tank?

[GallagherAtWar]

How heavy is a 114 ci nitro tank?

is it so heavy that i have to put it on a remote?

If so how do i do that?

Brand New
Crossfire
Air / Nitrogen System
Including
114 cu Carbon Fiber tank
with 3000 psi Regulator
Crossfire Non adjustable 3000 psi Regulator with an output pressure preset range 850-900 psi i
Length: 11.75 in (without reg)
Width: 4.5 in
Gauge 4000 psi

[kickass68mag]

114

not heavy at all, just sold mine, get a kapp dz2 and mount the tank by the neck and it will be sweet, that is what i did.

[markhauguel]

I have probably the same crossfire tank. I had more of a problem with length than weight. I had problems using my gas thru foregrip and a long drop forward. I ended up ditching the grip and kept the tank. I think its great to be able to go through most of a case without refilling. There are the occasional comments about the blimp following my gun though. Of course they miss the next game to go to the filling station. Ha Ha

[GallagherAtWar]

so what do i buy to run it off a remote?
or run it thruogh gas thourgh grip?

[markhauguel]

I used a CP flame drop and a benchmark tank adapter because I liked the way it looked. a Kapp extender would look if you can have the grip a little farther forward. The problem I had is long drops like the Psycho Ballistics didn't drop fast enough to clear my foregrip with a macroline on the bottom. If you have a classic I would run a line right from the reg with a quick disconnect and a small foregrip. I like on gun setups vs. remote because I like packs like my reds 4 across or the jt pack. I don't mind holding up the gun. I have played for 7-8 hours straight and was not tired. I hope this helps. A DZ2 would have fit but I didn't have a tank adapter and I like to take my tank off the gun to be refilled.

[GallagherAtWar]

You got a pic of ur gun??

[markhauguel]

here it is :



thanks

[GallagherAtWar]

THANKS A LOT FOR THE PICTURE
i hadn't the clue what you're where talking about untill i saw the picure

How many shots u get with your tank?

[markhauguel]

When I can get it filled to 3000psi I get around 1200-1500 out of it.

[kenshinkandon]

About your pic

How did you get your inlet hole on the other side of the valve it is very interesting. did you just drill a hole in your valve or did you have it specaially made

[markhauguel]

There were a few, I don't know how many, minis made with the inlet on the left and I happen to have one. I like to say it was specially made for me but that is not the case. I have not seen another one though. Maybe someone knows the story behind this.