hey guys, i stripped a screw in my stock trigger frame, and my boss gave me a new frame with the gaurd cut off already cause i have the double trigger in the mail. how do i get the safety + trigger out? i've taken out the set screw and the spring thats inside.
-
My Shocker: Fs/Ft
2k Shocker 4x4 with horizontal max-flow,double trigger,pure energy 45/3k,16"AA, Evo II, on/off mod,IPB Derlin bolt, 9 volt mod, gadget grip, DOP drop forward
Contacts: AIM:Volklski420
MSN:[email protected]
Yahoo: P8intballer20
E-Mail:[email protected] -
If you haven't figured it out yet here is my two cents.
Remove the trigger pin and the safety pin and it should come out.Welcome to my mind. Be carefull were you step because the floor is kinda sllipery.
A.K.A Ducky DC (on other forums)
A.K.A Odie Wan (on other forums)
PTI Air Smith/Tech
PTI Referee
PRO Referee -
i just installed a double trigger on an old frame i bought from a friend. you have to take the little spring out, #39 on the above diagram, and make sure you dont lose it or the little ball thats right below it. Once you remove those, the safetey pin slides out quite easily. Then use a small punch and a hammer to remove the trigger pin, and the trigger falls right out. Once you get the new trigger in, put the trigger pin in, then the safety pin in the same direction it was in to begin with, and put the little ball and spring back in.Comment
Comment