Warp Feed Problems

[MILKMAN]

I just purchased an older Pro team products warp feed and it came with the 12V & on/off mods. It seems to only have the external sensor, which the wire is severed, is there any other internal sensor in this kind of warp?

Thanks for your time....MILKMAN

[ignatz]

I don't think the first gen ProTeam warps had an internal sensor. To check, remove the small black cover on the back of the warp... if you see a blue potentiometer (sp?) in the upper right hand corner area then it should have internal sensor. If there is a sensor, you should position the jumpers in the default position. See the thread all about WARPs in this section for more info. Also, if your warp only takes an external sensor PM me and maybe we can work out a trade for my external sensor.

[xen_100]

I may be wrong, but I would think the board would be the same, even if the internal sensor was missing. you could just buy the internal sensor and sensor springs.

http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=69&CATID=6

http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=66&CATID=6

only $7

[MILKMAN]

Thank you both very much, AGD's store must be down right now, but when it gets back up, I'll let you know the situation. The picture below is the board with the back panel taken off, does it have internal sensors??? Thanks again...MILKMAN

[ignatz]

It has the interal pot, but I think that xen maybe right do you see anything that looks like the pic in his first link inside of the warp?

[xen_100]

it defintaely has the internal sensor circuitry stuffed on the board. The sensor is behind that. you can see it from the outside. Look right below the little bubble that the board is in. if it is there, all you have to do is make sure you have the jumpers set to use the internal sensor and then set the pot so that it is sensitive enough for your gun.

(easiest way to do that is just turn it up all the way.(closkwise) it will start to turn constantly, then back off the pot until it just stops spinning. a hard tap on the side of the warp should make it spin.)

if you have a way to intellifeed it, I would that though. I never really liked the internal sensor on the warp. even on a spyder(which was plenty of kick) it wouldn't always spin. plus it is voltage sensitive, so with new batteries it is more senitive than it is with batteries that are getting worn (not dead, just less than full power)

[MILKMAN]

You don't know how much I appreciate this, thanks a lot fellas.