Roller Trigger Questions

[mh53eplt]

I just bought a roller trigger, however it came without instructions Figures Does anyone have a link or schematic I can use to help me install it?

[jdev]

here I go with my best estimation of things.

you should have 4 screws, 2 trigger brackets, on one end, 2 screw holes and the other (the "tip") a "c" shaped piece, and the actual roller (2 i believe)

TAP 4 holes into the trigger 2 on each side (see my picture for estimation of where to tap)

tap the holes, screw the roller trigger brackets into the trigger, then snap in (I believe, but since you have the kit infront of you, use your best estimation, for all i know, the 2 roller pieces could screw into eachother) and you should be all set.

ALSO.. where did you get the kit from. im looking for one myself, but someone up and bought them all from AGD.

lmk.

thanks.

[mh53eplt]

thanks for the info. I ordered my roller kit from AGD. this is the link I ordered it from: AGD Online Store roller trigger kit They also sent me both styles of roller. cost is $25 if they don't have any in stock your CC will not be charged. good luck

[jdev]

thanks for the link, unfortunately, they are out of stock. If yours doesnt work out from you, i could take it off your hands

[mh53eplt]

appreciate the offer, but if I find I can't install it myself I'll just send it off to docsmachine and have him do it.

[WickeDKlowN]

What exactly does the roller trigger do?

[mh53eplt]

It is used for electro guns and you roll your finger up and down the roller to achieve increased rates of fire. (posted by thecavemankevin)

the original thread

http://www.automags.org/forums/show...=roller+trigger

a look at the product from AGD

http://www.automags.org/forums/show...=roller+trigger

use the search button and type roller trigger and check out the many threads on the subject.